FHA Single Family Housing Policy Handbook 4000.1, Part II — f. HUD Certification Label (09/14/2015)
FHA Single Family Housing Policy Handbook 4000.1, Part II — f. HUD Certification Label (09/14/2015).
Verbatim regulatory text
Verbatim provisions from FHA Single Family Housing Policy Handbook 4000.1, Part II — f. HUD Certification Label (09/14/2015) — each quote is a verified substring of the regulator-published source snapshot, not retyped. Quoted for reference; this is not legal advice. The operational layer (P&P updates, prompts) lives in the regulation update kits.
FHA Single Family Housing Policy Handbook 4000.1, Part II — f. HUD Certification Label (09/14/2015)
f. HUD Certification Label (09/14/2015) i. Definition HUD Certification Label, also known as a HUD seal or HUD tag, refers to a two inch by four inch aluminum plate permanently attached to Manufactured Housing. ii. Standard Manufactured Homes must have an affixed HUD Certification Label located at one end of each section of the house, approximately one foot up from the floor and one foot in from the road side, or as near that location on a permanent part of the exterior of the house as practicable. Etched on the HUD Certification Label is the certification label number, also referred to as the HUD label number. Label numbers are not required to be sequential on a multi-section house. II. ORIGINATION THROUGH POST-CLOSING/ENDORSEMENT D. Appraiser and Property Requirements for Title II Forward and Reverse Mortgages 5. Property Acceptability Criteria for Manufactured Housing for Title II Insured Mortgages Handbook 4000.1 858 Last Revised: 11/26/2025 iii. Required Analysis and Reporting The Appraiser must report the HUD label number for all sections, or report that the HUD Certification Label is missing or that the Appraiser was unable to locate it.
Operationalizing FHA Single Family Housing Policy Handbook 4000.1, Part II — f. HUD Certification Label (09/14/2015)
This is verbatim, source-snapshotted regulator text from the Claude for Compliance open corpus. To turn a rule like this into compliance work product: gap-analyze your policies and procedures (P&Ps) against these requirements to surface stale, conflicting, or missing provisions; operationalize any change with a ready-to-run update kit; and produce audit-ready evidence — every step grounded only in the regulator’s own words, never invented.
Source of record: https://claudeforcompliance.com/regs/hud-4000-1-ii-f-hud-certification-label/
· register hud-4000-1-ii-f-hud-certification-label · Claude for Compliance. Free to read and download;
see regulatory updates and methodology.